Concrete work across Pasadena
From a single pad to a full foundation. We cover Pasadena and the rest of Los Angeles County out of Hemet, with 32 years in the trade and a license to back it.
Talk to us about the job









What concrete is up against around Pasadena
Matching what stays
Replacing part of a run means matching the thickness, the finish and the joint pattern of what stays, so the job reads as one surface rather than a patch.
Access and staging
Dense lots mean narrow driveways, alley access, parked cars and nowhere to put a truck. Getting concrete to the pour is often harder than the pour, and it gets planned first.
Tree roots under flatwork
Mature street trees lift sidewalks and drives, and they will do it again to a new slab unless the root is dealt with. Sometimes that means root pruning, sometimes rerouting the walk.
Curing treated as a step
Fresh concrete gets protected from dry wind and sun until it has what it needs. Skipping that is how you get a dusty, weak top layer.
Pours scheduled to the heat
In summer we start early and keep the mix and the crew ahead of the temperature. Concrete does not wait for anybody.
One crew start to finish
The same people who form it pour it and finish it. There is no handoff where the details get lost.
What we build in Pasadena

Concrete Slabs
The flat pour everything else is a version of.

Concrete Slab Repair
Cracks and surface failure on a slab worth keeping.

Concrete Slab Replacement
When the base failed, the slab follows.

Garage Floors
Hot tires, dropped tools, and whatever ran off the car.

Garage Aprons
The strip between the driveway and the garage door.

Basement Floors
A slab poured inside, where moisture has nowhere to go.

Concrete Leveling
Lifting a slab back to where it started.

Concrete Grinding
Taking down high spots and trip lips.

Concrete Sealing
Keeping water out of the pores.

Utility Pads
Pads for meters, generators, and mechanical gear.

Bollard Foundations
The concrete that stops a vehicle.

Concrete Trash Enclosures
Walls, slab, and apron as one detail.
Pouring concrete around Pasadena
Matching a run that stays
Replacing part of a walk or drive means matching thickness, finish and joint pattern to what remains, so the result reads as one surface rather than a patch. Color takes time to blend as concrete ages and we will be straight about that up front.
Older slabs and older assumptions
Much of the concrete in these neighborhoods was poured decades ago, thinner than we would build now and with lighter reinforcement over a base nobody tested. When it fails it is usually reporting on what is underneath, which is why we look at the cause before quoting the cure.
Street trees and roots
Mature trees lift sidewalks and driveways, and they will lift a new slab too unless the root is dealt with. Sometimes that means root pruning, sometimes rerouting the walk, sometimes a thicker slab with a root barrier. Replacing without addressing it just resets the clock.
Access and staging
Dense lots mean narrow drives, alley access, parked cars and nowhere obvious to put a truck. Getting concrete to the pour is often harder than the pour itself, so access is worked out before the date is set, including whether the job needs a pump.

Concrete work around Pasadena
Flatwork, foundations and repair across Pasadena and the rest of Los Angeles County, poured by the same crew that answers the phone.
How concrete fails, and why
Settlement at the apron
The strip where a driveway meets a garage takes every vehicle and sits over backfill that was disturbed during construction. It settles more than the rest of the drive and it needs its own thickness and joint.
Heaving
A slab pushed upward is usually roots or expansive soil taking on water. Both get worse with irrigation, and neither is fixed by resurfacing the top.
Pop-outs
Small conical craters come from a particle of reactive aggregate near the surface expanding and blowing the concrete off above it. Cosmetic, and a repairable surface defect.
Dusting
A surface that chalks under a broom was finished or cured badly, or had water worked into it. Sealing helps; grinding and resurfacing fixes it.
How a job runs
Scheduling
Weather moves concrete dates, particularly in summer. We would rather move a pour than place into conditions that will not finish or cure properly.
Site access
A mixer is a large, heavy vehicle. Where it can park and how far the concrete has to travel changes the method and sometimes the price. That is worked out in advance.
A repair aimed at the wrong cause is money spent twice.On repair work
Protecting what stays
Existing flatwork, landscaping, and anything we are working next to gets protected. Concrete is messy while it happens.
Curing time
The slab is not finished when it looks finished. Curing continues for weeks and how it is protected in the first days affects the surface for the life of it.
Around Pasadena
Straight answers
Can you get a truck to my property?
That gets worked out before the date is set. Narrow drives, alley access and parked cars all decide whether the concrete arrives by chute or by pump.
How loud and disruptive is it?
Saw cutting and breaking concrete is loud and it is usually the first day. We will tell you which days those are so you can plan around them.
Am I liable for a lifted panel out front?
Generally the property owner carries that risk on a public walk, which is why grinding a lip or replacing a panel is cheap next to a claim.
My sidewalk is lifted by a tree root. What are the options?
Grinding the lip removes the trip hazard; cutting and repouring the panel fixes the surface. Neither lasts unless the root is addressed, which can mean pruning, a root barrier or rerouting the walk.
The concrete here is old and thin. Is that why it failed?
Often, along with a base nobody tested. Older urban flatwork was poured thinner with lighter steel, and when it fails it is usually reporting on what is underneath.
Pouring in Pasadena
We would rather stand on the job than guess at it. Call and we will set a time to come and look.

