Hemet, CA · California license 1137822 · C-8 Concrete
(951) 533-8821
Home
Services
Services
Residential
Commercial
Service Areas
Service Areas
Riverside County
San Bernardino County
Orange County
Los Angeles County
San Diego County
Kern County
GalleryAboutBlogContactCall (951) 533-8821
Skip to content
Crew screeding a concrete pour
Residential

Concrete Pool Decks

A pool deck is the one slab that is wet on purpose. Slip resistance is not an upgrade here, it is the specification. Drainage has to move water away from the coping, and the finish has to stay cool enough to walk on in a Hemet August.

Hemet, CA  ·  (951) 533-8821  ·  License 1137822

Talk to us about the job
Foundation rebar cage hires
Curb hillside run
Foundation mat rebar
Sidewalk long pour
Crew curb forming
Driveway wide formed
Subgrade cut trench
Stamped walkway charcoal
Driveway rebar formed
Driveway finished dark
Sequence

How the job runs

Step 1

A visit, not a guess

Concrete gets quoted on site. The soil, the fall, the access and the existing slab all change the job, and none of them show up in a text message.

Step 2

Honest scope

We say what the job needs. If a repair holds, we will tell you that instead of selling you a replacement.

Step 3

Earthwork first

Cut, correct, compact. The base is the job and the concrete is the finish on top of it.

Step 4

Steel and placement

Reinforcement where the drawing puts it, forms that do not bow, concrete consolidated into every corner.

Specifics

What this job actually needs

What decides the price

Access, thickness, the state of the base, how much demolition there is, and the finish. Square footage is the least interesting number. That is why somebody comes out and stands on the job rather than quoting off a photograph.

Base preparation

Cut to grade, find and fix the soft spots, place base in controlled lifts and compact it. Almost every residential slab failure we are called to look at started here rather than in the concrete.

Reinforcement and joints

Steel lifted into the upper part of the slab where tension happens, and control joints spaced to the thickness and cut early enough to work. Those two decisions are why some slabs look fine at twenty years and others are a map of cracks at five.

Curing in inland heat

Low humidity, wind and triple digit afternoons pull water out of a fresh slab faster than the concrete can use it. Curing is an active step here, not something that just happens, and it decides the strength of the surface.

What decides whether it lasts

Concrete is judged on the surface and it fails from underneath. The base, the steel, the joints and the cure are the whole job. A slab that was poured on bad ground will tell you so, usually in the third or fourth year.

Why fourth generation matters here

32 years on the tools means most of these problems have already been seen once. Reading a slab before quoting it is the part you cannot learn from a book, and it is the difference between a repair that holds and one that comes back.

Local conditions

What Southern California ground does to concrete pool decks

What the ground does here

The inland valleys run on expansive clay. It takes on water and swells, then dries out and shrinks, and it does that cycle every year. A slab poured on untreated clay rides that movement until something gives, which is why base preparation and reinforcement are the design rather than an upgrade. Where a soils report exists we build to it; where there is none, what we find during excavation tells us what the ground is going to do.

Irrigation against the slab

Almost every valley property waters something, and sprinklers running along a slab edge keep the base saturated year round. In expansive soil that is a slow way to undermine your own driveway. Where the water lands is worth looking at before blaming the concrete.

Older flatwork around here

A lot of valley concrete was poured thin, with light reinforcement, on a base that was never properly compacted. When it fails it is usually reporting on the ground rather than on the mix, and that is the difference between a repair that holds and one that comes back in a year.

Drainage on a flat lot

Valley lots are often close to level, which makes slope hard to find and easy to get wrong. Low points, cross-fall and where water actually leaves the property get worked out before the pour, because once the concrete is down the drainage is permanent.

Our work
Crew raking pour
Crew screeding pour
Crew troweling edge
What goes wrong

How concrete fails, and why

Cracks along a plumbing run

A trench under a slab that was not compacted is a soft line, and the slab cracks along it. Compaction in the trench matters as much as in the open.

Glazed surfaces that are slippery when wet

Over-troweling closes the surface to a polish. Indoors that can be a choice; on an exterior walk it is a hazard.

Deterioration under planters

Soil and constant moisture held against concrete leaches it and stains it. Anything permanently wet against a slab shortens its life.

Repairs that do not match

A repair poured with a different mix, finished differently, or cured differently will always read as a patch. Matching the finish and joint pattern is part of the job.

What to expect

How a job runs

Preparation you may need to do

Moving vehicles, clearing the area, and sometimes irrigation being shut off. We will tell you in advance what is on you.

Demolition day

Saw cutting, breaking, loading and hauling. It is the loudest and dirtiest part and it usually happens first.

The base is the job. The concrete is the finish on top of it.
On what actually matters

Pour day

Early start in summer. The crew works continuously until the slab is placed and finished, because concrete sets on its own schedule.

Keeping off it

How long depends on the pour and the weather. You will get a real number, not a generic one.

Related

Other residential work

Trowel edge aggregate

Concrete Driveways

The slab that carries a car every day of its life.

Crew finishing wide slab

Concrete Driveway Replacement

Out to the dirt, rebuilt from the base up.

Crew hand-screeding a fresh residential slab

Concrete Driveway Repair

Fix what is broken and leave what is sound.

Driveway side return

Concrete Patios

The outdoor room that starts as a flat pour.

Driveway side return hires

Concrete Patio Replacement

Take out the old slab, pour the one you actually wanted.

Crew portrait basement

Concrete Patio Repair

Cracks, settled corners, and surfaces that have gone rough.

Driveway charcoal wide

Concrete Walkways

Getting from the street to the door without a trip hazard.

Driveway dark finish

Concrete Sidewalks

Public-facing flatwork built to the spec the city will inspect.

Straight answers

How much does concrete cost?

It depends on access, thickness, base condition and finish, which is why we walk the job before giving a number. We will not quote a driveway off a photograph.

How long before I can drive on a new slab?

Concrete takes most of its strength in the first week and keeps gaining for a month. Foot traffic is usually fine after a day or two. Vehicles wait longer, and we will give you the actual number for your pour, because thickness and weather both change it.

Do you fix the base or just pour over it?

We fix the base. Pouring new concrete on ground that already failed once is how you get the same crack in the same place. If the base is the problem, that is the work.

Can you match my existing concrete?

Usually close, rarely exact. Concrete changes color as it ages, so a new pour next to a ten year old slab will read newer for a while. We match thickness, finish and joint pattern so it looks intentional.

Will it crack?

Yes, eventually, and that is the material rather than a defect. The job is deciding where. Control joints put the crack on a line we cut instead of one it picks. A slab with no cracking plan will still crack, just somewhere you did not want.

Tell us what the job is

We walk the job, tell you what it needs, and give you a number. Hemet and roughly 100 miles around it.