Hemet, CA · California license 1137822 · C-8 Concrete
(951) 533-8821
Home
Services
Services
Residential
Commercial
Service Areas
Service Areas
Riverside County
San Bernardino County
Orange County
Los Angeles County
San Diego County
Kern County
GalleryAboutBlogContactCall (951) 533-8821
Skip to content

Laying Out a Patio on an Open Lot

Plenty of properties around Anza have room to put a patio almost anywhere, and that freedom is where the mistakes start. On a cramped suburban lot the patio goes behind the back door because there is nowhere else for it. On open ground people pick a spot by how it looks from the kitchen window, pour it, and learn the first summer that it bakes from noon on, or that the evening wind comes straight across it with nothing in the way.

A patio is a room with no walls. Where it sits, and what you can add to it later, decides whether anybody uses it.

Spend a day watching the yard

The most useful thing an owner can do before calling us is pay attention to the yard for one full day. Where is the shade at four in the afternoon, when people actually want to sit outside? Which way does the wind blow in the evening, and where does the house block it? A patio tucked into the sheltered side of the house, or beside a stand of trees, can be comfortable on days when the open side of the lot is not.

Sun on concrete deserves a thought too. A light gray slab in full sun throws a lot of glare and heat back at you, and it gets hot under bare feet. A patio on the east side of a house catches morning sun and sits in shade by evening, which suits a lot of families.

We also read the ground. Shallow rock and decomposed granite are both common in this area, and a site sitting right on rock may need more digging or a slightly shifted footprint. We would rather know that before the layout is final.

Posts and footings come before the slab

Most patios on open ground end up wanting shade: a pergola, a shade sail, a roof extended off the house. Every one of those needs posts, and posts need footings. The clean way to get them is to decide where they stand before the patio is poured, and set the footings, or at least the anchors and sleeves, at the same time.

Bolting a heavy shade structure onto a finished patio can be done, but a slab is no footing. The edge of a patio is slim compared to what a post needs when wind gets under the roof and pulls up on it. Coring through the patio later to dig proper footings means patching holes in a surface you paid to look good.

If the shade is a few years off, plan for it anyway. Mark the post spots, set what has to go below grade and leave the rest for later. The same goes for an outdoor kitchen, a gas line or power for lights. Whatever runs under the slab goes in first.

The inside corner on an L-shaped patio

Patios that wrap a corner of the house, or step out into an L to catch a view, are popular and they look good. They also carry a weak spot that catches people out. An inside corner gathers stress in a slab, and the concrete will crack on a diagonal out of it unless steel or a joint is there to steer the movement.

We usually handle it both ways at once. Extra steel set across the corner holds a crack tight if one forms. A joint lined up with the corner gives the slab a straight place to move instead of letting it tear its own path. The same thinking applies anywhere the patio notches around a post, a chimney or a set of steps.

Curved edges avoid hard inside corners, which is one reason they hold up well, though the joints still have to be laid out with the curve in mind. You can see how we plan patios for Anza homes, and our concrete patios page covers the work in general.

Water leaves the patio, away from the house

Every patio needs a slight slope so water runs off it. Tip it the wrong way and the patio pours water against the foundation, and one laid against a back wall can collect a whole roof’s runoff if the gutters empty onto it. The fall should run away from the house, gentle enough that a table sits level to the eye and steep enough that a storm leaves no puddles behind.

Where the water goes after that is the next question. On a sloping lot the low side of a patio may be a bare bank, and a wide slab can dump enough water on it to carve a channel in a few storms. We plan for the runoff to leave onto rock, a swale or ground that can take it.

Downspouts are often the bigger problem. One dumping onto a patio corner keeps that spot wet all winter, and wet concrete going through a freeze is concrete that flakes. Moving a downspout is a small job, and it is worth doing before the patio goes in.

Where the patio meets the house wall, it gets a joint of its own rather than being poured hard against the foundation. The slab and the house move differently through a year of freezing and thawing, and that strip of joint material lets each one do it without the patio cracking along the wall or pushing on the siding. It also gets sealed, so water running down the wall does not find a gap to soak into.

Joints, size and the season you pour it

A large patio gets its control joints laid out in a plan, spaced to the slab and placed where it wants to move anyway: across narrow necks, out of corners, at every change in shape. Done well, the joints read as part of the design. Done carelessly, the slab cracks somewhere else and the joints just sit there.

Size matters in a second way. A big patio is a lot of concrete to place and finish while it is still workable, and the crew needs the hands and the plan to stay ahead of it. Getting the mixer to the backyard is part of that plan, and on a lot with a narrow drive or a steep approach it may mean pumping.

The finish is worth a conversation before the truck arrives. A patio gets wet from rain, from a hose and from whatever spills off the grill, and a surface troweled glass smooth turns slick the first time it frosts over. A light broom texture gives bare feet and shoes something to hold while still sweeping clean. If you want color or a pattern, that decision changes the timing of the whole pour day, so it gets made early.

Then there is the calendar. Some winter months up here are the wrong time to pour outdoor concrete, because cold slows the curing reaction and a slab caught by a hard freeze can be damaged before it gains strength. Since a patio is meant for the warm months anyway, winter is a good time to plan one and spring is a good time to pour it.

Stand on the spot with us

A patio planned around the sun, the wind and whatever you might add later is one you will actually use. If you have a spot picked out, or two you cannot decide between, call (951) 533-8821 or reach us through the contact page. We would like to walk the job with you and talk it through on the lot itself.