A set of concrete steps that has dropped and left a gap against the house is one of the most common things we get asked to look at. Sometimes the top step tips back toward the door. Sometimes the whole set has slid outward and cracked off the porch. Either way it happened slowly, and nobody paid attention until a heel caught the edge one night.
Steps are a small pour, but they carry people at the moment they are least careful: arms full, eyes on the door, in the dark or in the snow. They have to be built so they stay exactly where they were put.
Why steps drift away from the house
Most failed steps were set on ground that was never ready for them. The dirt right next to a foundation is usually backfill, pushed in after the walls went up and seldom compacted well. It keeps settling for years, and a step poured on top of it rides that settlement down and away from the wall.
Water does the rest. Roof runoff and a downspout by the door keep the soil under the steps wet, and in a freeze wet soil swells and lifts, then drops again in the thaw. Every winter the steps move a little and never quite come back to where they started.
Tie them to something that will not move
The fix is real support. Depending on the house, that means footings under the steps dug down to firm ground, steel tying the steps into the porch slab or the foundation, or both. Steps that bear on solid soil and connect to something solid stay put.
Around Anza the ground under a set of steps can turn out to be shallow rock or decomposed granite, and that changes how the footing gets dug and formed. Firm rock makes a fine base. Loose fill sitting on top of it does not, and it has to come out before anything gets poured.
Every riser the same height
Nobody looks at each step on the way up. Feet learn the first riser and expect the rest to match it. The set where one step is taller or shorter than its neighbors is the set people trip on, usually at the top or the bottom, where the steps meet the porch or the walk and somebody fudged the heights to make it come out.
We measure the total rise first, from the finished walk to the door threshold, and divide it evenly before a single form board is cut. If the walk at the bottom is going to change, that gets settled first, or the bottom riser ends up odd.
Tread depth gets the same treatment. A tread too shallow for a boot makes people come down sideways, and one that is deeper than the rest throws off their stride. Every tread on the set should be the same depth front to back, with the edge finished clean so it is easy to see in poor light. A slightly rounded nose holds up better than a sharp one and still reads clearly underfoot.
A landing at the door
A door that swings out over the top step makes you back down a step to open it, which is how people go over backward with a bag of groceries. Steps should end at a landing big enough to stand on while the door swings, with room to set something down and dig for the keys.
Where the door sits well above grade, the landing turns into a small porch, and that is a good thing. It gives the steps a solid top to tie into, and it gives you a spot to stamp the snow off your boots before you go inside.
Pitch each tread so it drains
A tread that is dead level holds a puddle on every step after a storm. Each tread should fall slightly toward its front edge so water runs off and down, while still feeling flat underfoot. The landing should fall away from the door for the same reason, so the threshold is not sitting in water that freezes the door shut overnight.
A downspout that empties onto the steps gets moved, no question. Roof water poured across a set of steps all winter freezes into the worst ice on the whole property.
Ice on the treads
Steps are where a slip does the most harm. A broom finish across each tread gives grip, and a little more texture at the front edge, where your foot lands, helps more. Smooth, slick steps look clean in the summer and turn dangerous with the first frost.
Ice melt is hard on steps because the corners and nosings get attacked from two sides at once. Salt sitting on concrete keeps it wet and eats at the edges first, which is why old steps so often crumble at the nose. Sand gives traction without chemicals, and a sealer helps keep water out of the edges. On any set of steps that sees snow, a handrail is worth talking about too.
Taking out a settled set
Steps that have dropped evenly can sometimes be lifted back into place. Steps that have cracked away from the house, rotated or broken into pieces are usually better replaced. Filling the gap with mortar or caulk looks fine for a season and opens right back up by spring.
Replacement means breaking out the old steps, hauling the concrete off, digging out the soft ground that let them move and starting over with a proper footing. We cover the siding, the door and the plants beside the steps while we work, and leave the area swept. Our concrete steps page for Anza goes through how we rebuild a set up here, and the main concrete steps page covers the work wherever we go.
Timing matters on a replacement. Some winter months at this elevation are a poor time to pour anything outdoors, so if your steps are failing in December, we book the new set for the first good stretch of weather rather than rush it.
Where the walk meets the bottom step
The bottom step and the walkway meet at a joint, and that joint should let the two move on their own. Poured as one piece, a walk that settles or heaves will crack the step. Poured tight with no joint material between them, one rubs and chips the other every winter.
Heights matter here as well. A walkway that ramps up to the step changes the bottom riser, so the walk and the steps get planned together even when only one of them is being poured now. On a property where the walk is tired too, doing both at once usually gives the cleanest result and the fewest joints to look after.
Have us look at the old ones
If your steps have pulled away from the house, tip toward the door or ice up every winter, call (951) 533-8821 or send a note through our contact page. Somebody will come up from Hemet, tell you whether the set can be saved and give you a number for whichever way makes sense.